ProEFI

Electronic Fuel Injection Discussion Forums
 
HomeFAQSearchRegisterUsergroupsLog in

Share | 
 

 Injector(s) turns off in run mode

View previous topic View next topic Go down 
AuthorMessage
Mbirt



Posts : 2
Join date : 2011-06-02

PostSubject: Injector(s) turns off in run mode   Sat Mar 17, 2012 11:13 am

Hey everyone,

Kettering FSAE having an issue with our ProEFI 48 setup on a Yamaha WR450f single-cylinder. Upon cranking, the engine fires as it should but then dies when it should enter the afterstart phase. The ignition sync quality and timing was confirmed good by replacing the EFI intake with the engine's stock carb. The crank-to-run rpm can be changed to a high number and the engine will run (richly) on its cranking PW. Removing the injector from the intake and spraying into a container using a pseudo rpm, it can be seen that the injector fires as it should until the crank-to-run rpm is exceeded and the injector stops spraying.

In an effort to fix this, we've copied the applicable settings from our running ProEFI 128 setup to the 48. This did nothing to change the condition, unfortunately.

Has anyone experienced a similar problem or have some good input to share?
Back to top Go down
View user profile
Admin
Admin


Posts : 258
Join date : 2008-02-22

PostSubject: Re: Injector(s) turns off in run mode   Tue Apr 10, 2012 8:45 am

Mbirt wrote:
Hey everyone,

Kettering FSAE having an issue with our ProEFI 48 setup on a Yamaha WR450f single-cylinder. Upon cranking, the engine fires as it should but then dies when it should enter the afterstart phase. The ignition sync quality and timing was confirmed good by replacing the EFI intake with the engine's stock carb. The crank-to-run rpm can be changed to a high number and the engine will run (richly) on its cranking PW. Removing the injector from the intake and spraying into a container using a pseudo rpm, it can be seen that the injector fires as it should until the crank-to-run rpm is exceeded and the injector stops spraying.

In an effort to fix this, we've copied the applicable settings from our running ProEFI 128 setup to the 48. This did nothing to change the condition, unfortunately.

Has anyone experienced a similar problem or have some good input to share?

Glad to hear you got it fixed Matt!
Back to top Go down
View user profile http://proefiforum.forumakers.com
 
Injector(s) turns off in run mode
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» Another 'no start' condition (SOLVED - new injectors)
» My bike won't start either...
» Bike will not start (fuel injector, fuel pump, HALL)
» My battery barely turns the starter. Could it be a bad a connection?
» X-Terra 70 beach mode & prospecting mode combined

Permissions in this forum:You cannot reply to topics in this forum
ProEFI :: ProEFI Forums :: General ProEFI Discussions-
Jump to: