ProEFI
Would you like to react to this message? Create an account in a few clicks or log in to continue.
ProEFI

Electronic Fuel Injection Discussion Forums
 
HomeSearchLatest imagesRegisterLog in

 

 CAN and or tps question

Go down 
2 posters
AuthorMessage
sniper




Posts : 2
Join date : 2011-10-08

CAN and or tps question Empty
PostSubject: CAN and or tps question   CAN and or tps question Icon_minitimeSun Oct 09, 2011 1:09 pm

Is there a way to pull tps or other data out of CAN 1 or 2?

Or is there a specific procedure for setting ADC on TPS? ie off pedal hit x, let off, full pedal hit y. And let the ecu set ADC.

Thanks

Well I seem to have the tps working properly. There appeared to be a conflict of signals.
But I would still like to know if there are other ways to grab signals from the CAN bus.

Back to top Go down
Admin
Admin



Posts : 258
Join date : 2008-02-22

CAN and or tps question Empty
PostSubject: Re: CAN and or tps question   CAN and or tps question Icon_minitimeTue Oct 25, 2011 10:13 am

sniper wrote:
Is there a way to pull tps or other data out of CAN 1 or 2?

Or is there a specific procedure for setting ADC on TPS? ie off pedal hit x, let off, full pedal hit y. And let the ecu set ADC.

Thanks

Well I seem to have the tps working properly. There appeared to be a conflict of signals.
But I would still like to know if there are other ways to grab signals from the CAN bus.


Are you talking about the factory CAN bus? Only some of the applications have pre-configured CAN signals being pulled from the factory CAN bus. This isn't something that is user configurable.
Back to top Go down
https://proefiforum.forumakers.com
 
CAN and or tps question
Back to top 
Page 1 of 1
 Similar topics
-
» A/F Scale Question
» Basic Strategy Question
» Kvaser CAN cable question
» User software question
» Data Logging Question

Permissions in this forum:You cannot reply to topics in this forum
ProEFI :: ProEFI Forums :: Products :: Sensors-
Jump to: