ProEFI

Electronic Fuel Injection Discussion Forums
 
HomeFAQSearchRegisterUsergroupsLog in

Share | 
 

 CAN and or tps question

View previous topic View next topic Go down 
AuthorMessage
sniper



Posts : 2
Join date : 2011-10-08

PostSubject: CAN and or tps question   Sun Oct 09, 2011 1:09 pm

Is there a way to pull tps or other data out of CAN 1 or 2?

Or is there a specific procedure for setting ADC on TPS? ie off pedal hit x, let off, full pedal hit y. And let the ecu set ADC.

Thanks

Well I seem to have the tps working properly. There appeared to be a conflict of signals.
But I would still like to know if there are other ways to grab signals from the CAN bus.

Back to top Go down
View user profile
Admin
Admin


Posts : 258
Join date : 2008-02-22

PostSubject: Re: CAN and or tps question   Tue Oct 25, 2011 10:13 am

sniper wrote:
Is there a way to pull tps or other data out of CAN 1 or 2?

Or is there a specific procedure for setting ADC on TPS? ie off pedal hit x, let off, full pedal hit y. And let the ecu set ADC.

Thanks

Well I seem to have the tps working properly. There appeared to be a conflict of signals.
But I would still like to know if there are other ways to grab signals from the CAN bus.


Are you talking about the factory CAN bus? Only some of the applications have pre-configured CAN signals being pulled from the factory CAN bus. This isn't something that is user configurable.
Back to top Go down
View user profile http://proefiforum.forumakers.com
 
CAN and or tps question
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» Pulley Question
» grip strength advice..ask david horne any question on grip training....
» Level Adjust Question
» Best forum question and answer ever!!!!
» Water and waste tanks question

Permissions in this forum:You cannot reply to topics in this forum
ProEFI :: ProEFI Forums :: Products :: Sensors-
Jump to: