ProEFI

Electronic Fuel Injection Discussion Forums
 
HomeFAQSearchRegisterUsergroupsLog in

Share | 
 

 trac control

View previous topic View next topic Go down 
AuthorMessage
jimmy



Posts : 26
Join date : 2009-08-09

PostSubject: trac control   Tue Dec 28, 2010 6:40 pm

Hay Jason, just wanted to know if there is a way to set the trac up to alow more cut or more wheel slip? Mine in set for 15 at this time and wanted to know on the supra what setting would I ply with for this? Would like to try out street tires on the track but do not want to spin too much and wheel hop.
Back to top Go down
View user profile
Admin
Admin


Posts : 258
Join date : 2008-02-22

PostSubject: Re: trac control   Sun Jan 09, 2011 6:24 pm

jimmy wrote:
Hay Jason, just wanted to know if there is a way to set the trac up to alow more cut or more wheel slip? Mine in set for 15 at this time and wanted to know on the supra what setting would I ply with for this? Would like to try out street tires on the track but do not want to spin too much and wheel hop.

Ofcourse there is. The '15' number is the percent over allowed before a differential wheel slip exceeded fault is triggered. From there, you decide how to handle the exceeded slip....hard rev limiter, soft limiter, base boost, turn off nitrous...etc... The slip table is slip allowed by vehicle speed. So if you are getting what you feel is excessive slip, lower the numbers at that point in your slip allowed table. You can also pull more timing up to the point of wheel slip exceeded.
Back to top Go down
View user profile http://proefiforum.forumakers.com
 
trac control
View previous topic View next topic Back to top 
Page 1 of 1
 Similar topics
-
» Dead battery, Climate control stuck on,trac light stuck off
» Micron Radio Control
» Front control arm bushings
» E-trac on the gold
» The Unspoken truth about Aftermarket Control Arms...

Permissions in this forum:You cannot reply to topics in this forum
ProEFI :: ProEFI Forums :: General ProEFI Discussions-
Jump to: